Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and remove the batteries before adjusting tool or installing accessories.
Lock Nut (20)
Threaded Insert (24)
Upper Leg (15)
Tapered Bushing (19)
Figure 2
Note: When adjusting the length of the Metal Detector, be careful to keep the plastic Tapered Bushing (19) in place with the smaller end toward the smaller end of the Lock Nut (20).
1.To attach the two legs, slide the Threaded Insert (24) over the end of the Upper Leg (15), making sure that the tabs inside the Insert lock into the
around the two Legs. Rotate the Nut counterclockwise to lock the Legs.
2.To adjust the length of the Legs, turn the Lock Nut in a clockwise direction, slide the Lower Leg to the desired extension length and turn the Nut counterclockwise to secure the Legs together.
3.To adjust the angle of the Search Coil, loosen the Coil Pivot (21) and Knob Bolt (22) and tilt it. Position the Search Coil so that it is parallel to the ground when holding the unit by the Handle with your arm in the Arm Support (13).
4.If needed,
Batteries
1.Make sure the On/Off/Volume control is set to OFF. Slide the Battery Cover
(26)off of the back of the Control Box and insert six AA batteries (sold separately), aligning polarities as indicated. Replace the Battery Cover.
Note: Use only fresh batteries of the required size and type. Do not mix old and new batteries, different types (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
Always remove old or weak batteries. Batteries can leak chemicals that can destroy electric parts.
If you do not plan to use the detector for a week or more, remove the batteries.
Page 6 | For technical questions, please call | SKU 67378 |
