5.Allow the Engine to run for several seconds. Then, if the Choke lever is in the CHOKE position, move the Choke Lever very slowly to its RUN position.
Note: Moving the Choke Lever too fast could stall the engine.
5
CHOKE RUN
SAFETY
IMPORTANT: Allow the engine to run at no load for five minutes with no load after each start‑up so that the engine can stabilize.
6.Adjust the Throttle as needed.
7.Break-in Period:
a.
b.The operational
•Do not apply a heavy load to the equipment.
•Do not operate the engine at its maximum speed.
c.The maintenance
•Change the engine oil.
Under normal operating conditions subsequent maintenance follows the schedule explained in the MAINTENANCE AND SERVICING section.
SETUP
Stopping the Engine
1. To stop the engine in an emergency, | OFF |
turn the Engine Switch off. |
2.Under normal conditions, use the following procedure:
a.Slide the Throttle or Speed Control Lever to SLOW (the “turtle”).
b.Turn the Engine Switch off.
c. Close the Fuel Valve.
OPERATION
MAINTENANCE
Horizontal Engines | For technical questions, please call | Page 13 |