trapped line pressure, and detach air supply hose from the air supply.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a good safety measure to attempt to discharge the tool in a safe fashion after disconnecting to ensure that the tool is disconnected and unpowered.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
Tool Set Up
To prevent serious injury:
Do not adjust or tamper with any control or component in a way not specifically explained within manual. Improper adjustment can result in tool failure or other serious hazards.
1.For added stability, attach Side Han- dle (5) to side of Hammer Case (4) using Bolts (6) and Washers (7). .
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route air hose along a safe route to reach work area without creat- ing a tripping hazard or exposing air hose to possible damage. Also avoid sharp bends and do not place items on hose during use.
3.The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.
4.There must not be hazardous objects
(such as utility lines) nearby that will present a hazard while working.
General Operating Instructions
1.WARNING! Use only 1” Drive Impact type sockets (not supplied).
2.If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use.
3.Push and snap socket (not included) onto Anvil (13).
4.This Impact Wrench can be used in either Forward or Reverse direction. To operate in Forward, turn the Direc- tion Knob (33) under the housing to the desired Forward speed.
NOTE: There are three torque settings for the Forward direction. To tighten, place the socket over the hex nut you wish to tighten.
SKU 68128 | For technical questions, please call | Page 8 |
