Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions |
Decreased output. | 1. Not enough air pressure and/ | 1. | Check for loose connections and make sure | |
|
| or air flow. |
| that air supply is providing enough air flow |
|
|
|
| (CFM) at required pressure (PSI) to the tool’s |
|
|
|
| air inlet. Do not exceed 90 PSI maximum |
|
|
|
| air pressure. |
| 2. | Obstructed trigger. | 2. | Clean around trigger to ensure free |
|
|
|
| movement. |
| 3. | Incorrect lubrication or not | 3. | Lubricate using air tool oil and grease |
|
| enough lubrication. |
| according to directions. |
| 4. | Blocked air inlet screen (if | 4. | Clean air inlet screen of buildup. |
|
| equipped). |
|
|
| 5. | Air leaking from loose housing, | 5. | Make sure housing is properly assembled |
|
| hose or connections. |
| and tight. Repair hose/connection air leaks. |
| 6. | Mechanism contaminated. | 6. | Have qualified technician clean and lubricate |
|
|
|
| mechanism. Install |
|
|
|
| as stated in Initial Set Up: Air Supply. |
| 7. | Vane wear or damage. | 7. | Replace all vanes. |
Housing heats | 1. | Incorrect lubrication or not | 1. | Lubricate using air tool oil and grease |
during use. |
| enough lubrication. |
| according to directions. |
| 2. | Worn parts. | 2. | Have qualified technician inspect internal |
|
|
|
| mechanism and replace parts as needed. |
Severe air | 1. | 1. | Check for incorrect alignment and uneven | |
leakage. |
| components. |
| gaps. If |
|
|
|
| replace damaged parts before use. |
| 2. | Loose housing. | 2. | Tighten housing assembly. If housing cannot |
|
|
|
| tighten properly, internal parts may be |
|
|
|
| misaligned. |
| 3. | Damaged valve or housing. | 3. | Replace damaged components. |
| 4. | Dirty, worn or damaged valve. | 4. | Clean or replace valve assembly. |
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
SKU 68128 | For technical questions, please call | Page 11 |
