Chisels with approved replacement Chisels from Harbor Freight Tools.
8.Check that all mounting screws are tightened. Retighten any loose screws.
9.Store in temperatures no lower than
10.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
Replacing Carbon Brushes
NOTE: The Breaker Hammer will cease operation once Carbon Brushes are worn. Check Brushes every
hours and replace when necessary.
1.Remove the Fan Cover (10) by loosening the Hex Bolt (12) and Flat Washers (11). See Figure 5, below.
2.Slide Fan Cover off of Housing (1).
3.Remove Brush Cap (5) from Housing.
4.Remove old Carbon Brush (6).
5.Insert new Carbon Brush.
6.Replace Carbon Brush Cap and slide Fan Cover back over Housing.
7.Replace Hex Bolts and Flat Washers until securely fastened.
8.WARNING! Verify all bolts and connectors are fastened tight.
Cleaning
1.Clean the Electric Hammer with warm water, soap a soft cloth, preferably after each use.
2.WARNING! Do not use solvents when cleaning the Electric Hammer. Doing so can damage the tool.
|
| Carbon |
|
Housing (1) | Brush Cap (5) | Brush Holder (7) | Fan Cover (10) |
|
|
| |
| Carbon Brush (6) |
|
|
Hex Bolt
(12)
Flat
Washer
(11)
Figure 5
SKU 68147 | For technical questions, please call | Page 11 |
