OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working. If working in the ground or on a concrete slabe on the earth, call local utility company to ensure that area is clear of utility lines.
Mounting Tool Bits
1.WARNING! Before installing new bit, unplug Electric Hammer.
2.Turn Lock Lever (74) 180° and slide out.
3.Insert the shank portion of the chisel into Front Cover (75). See Figure 2, below.
Chisel
Lock | Front |
Lever (74) | |
Figure 2 | Cover (75) |
|
4.Turn Lock Lever back to original position, locking chisel into place. Pull chisel to verify it is secure.
General Operating Instructions
1.Set the bit against the work area.
2.Place one hand on the Side Handle (31A) and the other hand around the Main Handle (86).
3.Press the Switch Lock Pin (84) and then push down on the Switch Trigger (82). See Figure 3, below.
Switch Trigger
(82)
Main Handle
Switch Lock (86)
Pin (84)
Figure 3
4. Push the tip forcibly down in order to begin striking material.
5. WARNING! Once activated, do not press, bear down or thrust forcibly
SKU 68147 | For technical questions, please call | Page 9 |
