SPECIFICATIONS
Electrical | 120 V~ / 60 Hz / 7.5 A (Rated) | |
Input | ||
| ||
Motor Speed | ||
| 1/2” in Steel | |
Drilling | 5/8” in Masonry | |
Capacity | 1” in Wood | |
| (Hammer Drill and Drill mode) | |
Chuck | 1/16” to 1/2” | |
Capacity | Three Jaw Key Type |
UNPACKING
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
INSTRUCTIONS FOR PUTTING
INTO USE
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION: Turn the Trigger
(32)off and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
Depth Gauge (45)
Chuck (3) |
|
Side |
|
Handle (46) | Power Cord (35) |
| |
Figure 1 | Key Holder |
1.Loosen the grip on the Side Handle
(46) and slide Side Handle clamp over and behind the Chuck (3) until it is set against housing.
2.Rotate the Side Handle until it is in desired orientation. If you are right- handed, position the Side Handle so it extends from the left of the housing, as shown Figure 1 above.
3.Rotate Side Handle clockwise to secure the clamp.
4.To install the Depth Gauge (45), loosen the Side Handle and slide the Depth Gauge into the gauge hole. See Figure 1, above.
5.Set Depth Gauge to required depth and retighten grip to fasten Depth Gauge into place (read further explanation under General Operating Instructions).
Page 8 | For technical questions, please call | SKU 68169 |
