OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
3.If possible, secure loose work pieces using a vise or clamps (not included) to prevent movement while working, if possible.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
Tool Set Up
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION: Turn Tool off, unplug from its electrical outlet and remove Drill Chuck Key before adjusting tool or installing accessories.
The Hammer Drill is equipped with a keyed Chuck. Follow these steps to insert bit:
1.Insert Chuck Key (2) into the Chuck and turn counterclockwise to open the Chuck.
2.Insert the hammer bit or the drill bit (not included) all the way into the Chuck.
3.Turn the Chuck Key clockwise to tighten the Chuck on the bit. When not in use, the Key can be stored in the key holder on the Power Cord (35).
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe path to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
General Operating Instructions
1.Plug Power Cord into a working outlet.
2.Set Direction Switch (40) to correct position. For clockwise (forward) rotation, push it from left side (Switch surface is marked with “R”). See Figure 2, below.
3.To rotate Chuck in a counterclockwise (reverse) direction, push it from the left side (Switch surface is marked with “L”).
WARNING! Do not change rotation direction while the Chuck is rotating.
Direction
Switch (40)
Speed Control Knob
| Trigger (32) |
Figure 2 | Trigger |
| |
Figure 2 | Lock |
Button |
4.Verify bit is securely locked in Chuck.
5.Press Trigger to activate. Obeserve rotating bit, making sure it does not wobble. If it does, back off Chuck and reposition the bit.
SKU 68169 | For technical questions, please call | Page 9 |
