Working Through a Blockage
1.If cutting tool becomes lodged in blockage and Drain Cleaner is still operating, the cable will start to wind up or twist. If so, immediately turn off, let tension release, and then pull back on cable to free cutting tool from the drain blockage.
If cable cannot be freed by pulling back, briefly turn the motor on in REV setting to free the tool.
WARNING! Do not keep cable rotating if tool is lodged in a blockage.
If tool stops turning and drum keeps rotating, cable can twist, kink, break, or tangle in the drain.
2.Once tool is free of blockage and is turning again, slowly feed rotating cutting tool back into blockage. Do not force tool through blockage.
3.Allow the spinning and cutting to break up and work its way through the blockage.
CAUTION: While working through the blockage, the tool and cable can get clogged with debris and cuttings from blockage, preventing further cleaning. The cable and tool will then need to be retrieved from drain and the debris removed. See “Retrieving the Cable” section.
SAFETY
If Cutting Tool Lodges in Drain:
1.If cutting tool stops turning and cable cannot be pulled from blockage, release Foot Switch while holding cable with both hands.
WARNING! Do not remove hands from cable or cable may kink, twist and break.
2.The Drain Cleaner motor will stop and cable and drum will turn backwards until tension in cable is released.
WARNING! Do not remove hands from cable until all the tension is released.
3. Place Rotation Switch in OFF position.
SETUP
Freeing Lodged Cutting Tool
1.Release Foot Switch and turn the Rotation Switch to OFF position.
2.Pull back on the cable to free it from the blockage. If the tool will not come free,
place the Rotation Switch in Reverse position.
3.
WARNING! Do not operate Drain Cleaner in Reverse for any longer than is needed to free the cutting tool from blockage
(for no more than several seconds at a time).
4.Hold the cable with both gloved hands, press the Foot Switch for several seconds, then release, and pull on the cable until it is free of the blockage.
5.Place the Rotation Switch in the Forward position and continue cleaning the drain.
OPERATION
Retrieving Drain Cleaner Cable
1.Once the drain is clear, turn on the faucet or use a hose to flush the debris out.
NOTE: Pay attention to the water level.
There could be blockages farther down in the drain.
WARNING! Do not pull cable from
drain while cable is still rotating. Cable end can whip around, causing serious injury.
2.Pull the cable from the drain by hand and feed into the Drain Cleaner until the cable is a couple of feet from the drain opening.
A flow of water down the line will help to clean the cable as it is retrieved. (If necessary, change the cutting tool and continue cleaning.)
3.Set the Rotation Switch to the OFF position, dry your hands, and unplug the machine before removing end of cable from drain and returning it to the drum.
NOTICE
Rotation Switch controls rotation of drum only. DO NOT USE ROTATION SWITCH REVERSE POSITION WHILE REMOVING CABLE FROM PIPE. Use reverse direction only momentarily for relieving pressure or untangling cable from a blockage.
Warranty void if cable damaged from allowing motor to twist excessively against blockage, or if drum is run in reverse long enough to unwind cable.
Item 68284 68285 | For technical questions, please call | Page 15 |
MAINTENANCE
