![](/images/new-backgrounds/1331778/3317785x1.webp)
Tool Use and Care (cont.)
3.Store the tool when it is idle out of reach of children and other untrained persons.
A tool is dangerous in the hands of untrained users.
4.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that affects the tool's operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
5.Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended for use with the specific tool model, increases the risk of injury to persons.
Safety
Service
1. Tool service must be performed only | 3. Use only the lubricants supplied with the |
by qualified repair personnel. | tool or specified by the manufacturer. |
2.When servicing a tool, use only identical replacement parts. Use only authorized parts.
Air Source
Setup
1.Never connect to an air source that is capable of exceeding 200 psi.
Over pressurizing the tool may cause bursting, abnormal operation, breakage of the tool or serious injury to persons.
Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated
2.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source
for the tool. Such gases are capable of explosion and serious injury to persons.
Safety Symbol Definitions
Symbol | Property or statement |
PSI | Pounds per square inch of pressure |
|
|
NPT | National pipe thread, tapered |
|
|
| WARNING marking |
| concerning Risk of Eye Injury. |
| Wear ANSI‑approved eye protection. |
Symbol | Property or statement |
| WARNING marking concerning |
| Risk of Respiratory Injury. Wear |
| NIOSH‑approved dust mask/respirator. |
| WARNING marking concerning |
| Risk of Explosion. |
|
|
Operation
Specific Safety Instructions
1.The warnings and precautions discussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
2.Obey the manual for the air tool and air compressor used with this tool.
3.Install an
4.WARNING: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249.5, et seq.)
Maintenance
Save these instructions.
Item 69234 | For technical questions, please call | Page 3 |