Troubleshooting |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Problem |
|
| Possible Causes |
| Likely Solutions | |
Motor will | 1. | Cord not connected. | 1. | Check that cord is plugged in. |
| |
not start. | 2. |
| No power at outlet. | 2. | Check power at outlet. If outlet is unpowered, | |
|
|
|
|
| turn off tool and check circuit breaker. If breaker | |
|
|
|
|
| is tripped, make sure circuit is right capacity | |
|
|
|
|
| for tool and circuit has no other loads. | |
| 3. |
| Fuse is blown or breaker tripped. | 3. | Turn off and unplug pump, have fuse replaced | |
|
|
|
|
| by a qualified service technician. | |
| 4. |
| Internal damage or wear. (Carbon | 4. | Have serviced by a qualified service technician. | |
|
|
| brushes or switch, for example.) |
|
|
|
Motor runs | 1. |
| Improper priming. | 1. |
| |
but water isn’t | 2. |
| Clogged filter at end of | 2. | Clean filter. | |
pumping. |
|
| intake connections. |
|
|
|
| 3. |
| Discharge valve closed. | 3. | Open discharge valve. | |
| 4. |
| Pipe size too small. | 4. | ||
|
|
|
|
| the Pump inlet and outlet ports. | |
| 5. |
| Impeller plugged. | 5. | Have Impeller cleaned by qualified service technician. | |
| 6. |
| Pipes frozen. | 6. | Thaw pipes. Check for damage before using pump. | |
Pump does not | 1. | Corroded pipes. | 1. | Replace pipes. |
| |
deliver water at | 2. |
| Piping size too small. | 2. | ||
full capacity. |
|
|
|
| the Pump inlet and outlet ports. | |
| 3. |
| Not enough water supplied to Pump. | 3. | Enlarge inlet pipe. Check well pump system. | |
| 4. |
| Low Voltage. | 4. | Check that outlet is 120V. | |
Excessive noise | Internal damage or wear. (Carbon | Have technician service tool. |
| |||
or rattling. | brushes or bearings, for example.) |
|
|
|
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTA- TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES That ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Page 6 | For technical questions, please call | SKU 69297 |