Troubleshooting
Any internal repair should be performed by an authorized service technician.
Symptom | Cause | Solution |
|
|
|
Top of tool or Trigger | Loose Screws, | Verify screws are tight, |
(47) leaks air | Worn or damaged | Check/replace |
Sluggish operation, or | Inadequate air supply, | Use a compressor that delivers |
will not operate |
| the proper CFM, |
| Inadequate lubrication, | Add air tool oil (not incl.), |
| Worn/damaged | Check/replace |
|
|
|
Bottom of tool leaks air | Loose Screws, | Verify screws are tight, |
| Worn/damaged | Check/replace |
|
|
|
Frequent Jamming | Incorrect fasteners, | Verify fastener size, |
| Damaged fasteners, | Replace fasteners, |
| Magazine (76) or Nose screw loose, | Tighten screws, |
| Dirt inside Magazine, | Clean Magazine, |
| Worn or damaged Driver Unit | Inspect Driver Unit |
|
|
|
Note: Contact Harbor Freight Tools for repair/replacement parts.
Maintenance
Disconnect the Nailer from the air source hose before attempting any maintenance.
1.Wipe tool clean with a lint free cloth and inspect it for damage. Do not use the tool if you find damage. Have it repaired by an authorized service technician.
2.Always test the Full Sequential Safety mechanism before each use (see page 6).
3.Keep all screws tight. Loose screws may damage the tool and cause personal injury.
4.Make sure that Base (29) is clear of all dirt or debris.
SKU 91044 | For technical questions, please call | Page 10 |
