ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagrams on pages 26 and 28.

To Attach A Power Cord Plug:

1. WARNING! Only a qualified, certified electrician should attach a 220 volt Power Plug (not included) to the Power Cord of the Welder.

2.For further instructions, refer to page 5 and page 6 of this manual.

To Attach The Rear Wheels And Front Castor Wheels:

1.WARNING! Prior to performing any further assembly procedures, make sure the Power Cord Plug of the Welder is unplugged from its electrical outlet.

2.To attach the two Rear Wheels (47) to the Welder, slide a Wheel onto each end

of the Axle located at the rear of the Base (19). Secure both Wheels to the Axle by inserting one Cotter Pin through each end of the Axle. Once inserted, make sure to spread each Cotter Pin to keep them in place. (See Figure G.)

3.To attach the two Front Castor Wheels (48) to the Welder, align the four holes in each top plate of a Castor Wheel with the four threaded mounting holes located in each corner at the bottom/front of the Welder. Use four Bolts (45) and four Washers (46) to secure each Castor Wheel to the Base. (See Figure G.)

COTTER PIN (44)

 

FRONT

AXLE

 

 

CASTOR WHEEL (48)

 

 

 

BASE (19)

 

 

WASHER (46)

 

 

 

FIGURE G

 

 

 

 

REAR WHEEL (47)

BOLT (45)

 

SKU 91146

For technical questions, please call 1-800-444-3353.

PAGE 14

Page 14
Image 14
Harbor Freight Tools 91146 operating instructions Assembly Instructions, To Attach a Power Cord Plug