4.To replace the 3 AMP Buss Fuse: Failure of the Welder to operate may be caused by a blown 3 AMP Fuse (7) as indicated by its melted wire strand within the Fuse. To replace the Fuse, unscrew and remove the Fuse Cap. Remove the old Fuse, and install a new 3 AMP Fuse. Then, replace the Fuse Cap.
5.When storing, make sure to store the Welder in a safe, clean, dry location out of reach of children and unauthorized users.
6.
CAUTION! All maintenance, service, and repairs not listed in this manual are only to be attempted by a qualified service technician.
INSPECTION, MAINTENANCE, AND CLEANING - WELDING GUN
1.
WARNING! Make sure the Power Switch (10) on the Welding Machine is in its “OFF” position. Unplug the Power from its electrical outlet, and allow the Welder to completely cool before performing any inspection, maintenance, or cleaning procedures. Note: Always ground the contact tip to insure that there is no residual energy in the Welder.
2.Before each use: Inspect the general condition of the Welding Gun. Check for damaged electrical wiring/gas hose, loose connections, cracked, burnt, or broken parts, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.Before each use: Clean welding spatter from the inside of the Gas Nozzle (100A) and spray with an
4.To replace the Gun Contact Tip: Cut off the welding wire at the Contact Tip (90A). Remove the Nozzle. Remove the old Contact Tip, and install a new Contact Tip. Then, replace the Nozzle. (See Figure O.)
CONTACT TIP (90A)
NOZZLE (100A)
FIGURE O
SKU 91146 | For technical questions, please call | PAGE 23 |
