UNPACKING

When unpacking, check to make sure all the parts shown on the Parts List on page 14 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

OPERATING INSTRUCTIONS

NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 15.

Battery Pack (14) and Adapter (20) Use

1.Plug the Adapter power cord into an outlet. When the Adapter (20) is plugged in, but not connected to the battery, both lights should be lit (if this is not happening exchange the adapter). When the battery is connected only the red light should be lit. When the battery is fully charged the red light should go out and the green light should come on. This may take up to 5 hours

2.Slide the Adapter into the slot on the top of the Battery Pack (14) until it clicks into place. To remove the Adapter, press the release button on the Battery Pack (14) and slide the Adapter (20) out. The Battery Pack (14) needs an initial charge of approximately 5 hours. After the initial charge, recharge the unit for approximately 3 to 5 hours. Never charge the battery more than 5 hours. See FIGURES 1 and 3.

3.To check the power level on the Battery Pack (14), press the TEST button on the Battery Pack (14). See FIGURE 2. Always after charging, use the TEST button to make sure a fully lit green light is on, showing a fully charged battery. When pushing the TEST button, if the lights are partially lit, that indicates a partial charge. When fully lit, Red = low charge, Yellow = 1/2 charge, Green = Full Charge. Test the Battery Pack periodically during operation and charge as needed.

Note: These lights show the approximate level of charge.

4.To load the Battery Pack (14) onto the Hammer Drill, just slide it along the bottom of the Base (13/17) until it clicks into place. Press the release button to remove the Battery Pack (14). See FIGURE 3.

FIGURE 1

FIGURE 3

Battery Pack (14)

State of

Charge LEDs

Adapter (20)

 

Base (13/17)

FIGURE 2

Battery

 

 

Pack (14)

Green Yellow Red

 

Close-up of

State of Charge LEDs

SKU 91176

PAGE 10

REV 12/04 REV 11/05

Page 10
Image 10
Harbor Freight Tools 91176 Unpacking, Operating Instructions, Battery Pack 14 and Adapter 20 Use, REV 12/04 REV 11/05