12.Keep all electrical connections dry and off the ground.
13.Do not handle the Power Switch (47) with wet hands.
14.Never leave the Chipper/Shredder unattended when it is plugged into an electrical outlet. Turn off the machine, and unplug it from its electrical outlet.
15.Allow the Blades (15) to spin up to full speed before feeding limbs into them. When turning off the Chipper/Shredder, allow the Blades to spin down and stop on their own. Do not press against the Blades with limbs or any other objects to stop them.
16.Do not force limbs into the Blades (15) when cutting. Apply moderate pres- sure, allowing the Blades to cut without being forced.
17.Never attempt to remove material stuck in the moving parts of the Chipper/ Shredder while it is plugged in.
18.Never stand on the Chipper/Shredder. Serious injury could result if the Chip- per/Shredder is tipped.
19.Industrial applications must follow OSHA requirements.
20.Keep all bystanders and animals safely away while operating the Chipper/ Shredder.
21.For your safety: In extreme working conditions, sensors in the Chipper/Shredder will automatically switch off the Motor to prevent overheating. In this event, turn the Power Switch (47) to its “OFF” position. Unplug the electrical cord and wait five minutes or until the Motor has cooled. Clear the machine of all debris. Plug in the electrical cord and depress the Circuit Breaker. Then, turn the Power Switch to its “ON” position to resume cutting. NEVER attempt to disable the Circuit Breaker.
22.Performance of this machine (if powered by line voltage) may vary depending on variations in local line voltage Extension cord usage may also affect machine performance.
23.Wait for sufficient time after shut down before performing any maintenance on the Chipper/Shredder. The Blades (15) do not stop immediately after turning off the power and unplugging the machine. Avoid injury by performing maintenance on the Chipper/Shredder only when all parts are cool to the touch.
24.
Avoid entanglement. Feed only one limb at a time into the Hopper
(1). Feeding two or more limbs at a time can entangle hands in the limbs, pulling fingers and hands downward into the spinning Blades (15).
SKU 92281 | For technical questions, please call | PAGE 9 |
