WATER PUMP
FLOW CONTROL KNOB (7) DRAIN PLUG (69)
FIGURE I | WATER |
| TRAY | |
| ||||
(67) | ||||
| ||||
To Make A Straight Cut:
1.
WARNING! Use safety equipment. Always wear eye protection. Wear ANSI approved safety glasses under an ANSI approved full face safety shield and
2.Loosen the Butterfly Knob (47) on the Angle Cutting Guide (46) and position the Angle Cutting Guide at 90 degrees to the Scale Rail (49). Then, retighten the But- terfly Knob (47) on the Angle Cutting Guide. (See Figure J.)
3.To Adjust the width between the Angle Cutting Guide (46) and a cutting slot in the Table (44), loosen the Butterfly Knob (47) on the Scale Rail (49). Move the Scale Rail to the desired position. Then, retighten the Butterfly Knob on the Scale Rail.
(See Figure J.)
4.Position the tile against the Scale Rail (49) and Angle Cutting Guide (46).
(See Figure J.)
|
|
|
| position of TILE | |||||||
SCALE RAIL |
|
|
|
|
|
|
|
|
|
| TABLE (44) |
|
|
|
|
|
|
|
|
|
| ||
(49) |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| |
BUTTERFLY KNOB (47) |
|
|
|
|
|
|
|
| ANGLE CUTTING | ||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
| GUIDE | ||
|
|
|
|
|
|
| |||||
FIGURE J | (46) | ||||||||||
|
|
| BUTTERFLY KNOB (47) | ||||||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
5.Check to make sure the water level in the Water Tray (67) is at the proper level (the Water Pump (7) should be about 3/4 submerged in water). Turn the Flow Control Knob on the Water Pump (7) all the way down. Then close the Water Tray com- pletely. (See Figure I.)
SKU 92386 | For technical questions, please call | Page 15 |
