8.While being careful not to scrape either the wall or the lantern, hang the Base
(1) of the lantern on the plastic hookon the Mounting Bracket (10) by the hole in the side of the Base - see Figure 1 on the previous page.
9.The included Wire Nuts (11) may not be suitable for all applications; ALWAYS make sure that all connections are se- cure and, if a wire nut will not tighten properly, supply one of appropriate size.
Using the wire nuts, carefully attach the wires in the lantern to the power supply lines. For each connection, twist the nuts over both wires clockwise until both wires are secure. NOTE: If any differ- ence from these directions is noted in the color/type of supply lines, have a licensed electrician finish the instal- lation. Secure the wires in the order explained below:
A. Attach the Black (hot) line to the Black wire.
B. Attach the White (neutral) line to the white wire.
C. If a Green (ground) line is present, attach it to the
If a Green (ground) line is not present and the outlet box is a grounded metal outlet box, then attach the
If a Green (ground) line is not present and the outlet box is not grounded, contact a licensed elec- trician.
Make sure that all connections are se- cure and that there is no metal showing on either the Black (hot) or White (neu- tral) connection before proceeding - see Figure 2, above right, for an example of a proper wire nut connection.
Figure 2
10.Turn the front part of the Mounting Bracket (8) until the Bracket Screws (9) are horizontal.
11.Carefully, so as not to pinch any wires or pull on any connections, slide the Base (1) off of the plastic hook and onto the Bracket Screws (9) so that the end of both Bracket Screws are visible at the front of the Base.
12.Thread the Acorn Nuts (10) onto the ends of the Bracket Screws (9) and tighten just enough to hold the Base (1).
13.Gently rotate the Base until the lantern is vertical. A level can be used to en- sure that the lantern is level.
14.Securely tighten the Acorn Nuts (10).
15.Apply weatherproof sealant (not in- cluded) around the top half of the base where it meets the wall.
DO NOT APPLY SEALANT TO THE
BOTTOM OF THE BASE.
The opening at the bottom allows mois- ture to drain out and helps prevent moisture from accumulating inside.
16.Install a type A light bulb rated at 100 watts or less, following the instructions outlined in number three of the Mainte- nance Instructions.
SKU 92508 For technical questions, please call | PAGE 6 |
