Harbor Freight Tools 92906 operating instructions Wing Assembly, Tail Assembly

Set out all parts on a clear and level surface prior to assembly.

Wing Assembly

1.Position the Left and Right Wings (1a,1b) inside the Bottom Wing Support (1d) as shown in Figure 1.

2.Align the Top Wing Support (1c) in top of the Bottom Support and fasten the wing assembly together using the six Wing Screws (18).

3.The Wing Assembly (1) should balance on a flat surface with about 2” to 23/8” distance from the wing tips to the table. The height of both sides should be roughly equal.

4.Insert the two tabs at the back of the Bottom Wing Support (1d) into the holes on the top of the Fuselage (3). Gently press the front of the Wing Assembly (1) into place. Secure with the two 1” Screws (20).

5.Hook a Wing Strut (5) into the tabs underneath one Wing - see Figure 2. Make sure that the tab at the other end of the Strut (5) is angled properly to fit into the bottom of the Fuselage

(3). Attach the strut to the bottom of the Fuselage (3) using a Strut Screw (23). Repeat for the other Strut and Wing.

Figure 1

Left

Wing (1a)

Bottom
Wing
Support	Right
(1d)
	Wing (1b)

Figure 2

Wing

Strut (5)

Left/Right

Wing (1a/1b)

Tail Assembly

1.Use two Tail Screws (22) to attach the Horizon- tal Stabilizer (2) onto the end of the Fuselage

(3).

2.Use the remaining Tail Screw (22) to attach the Vertical Stabilizer (21) onto the tab on the end of the Fuselage (3) - see Figure 3.

3.Connect the clips on both Pushrods (4) to the tabs controlling the rudder and elevators.

4.With Servos energized adjust the clips on the pushrods, until both the elevators and rudder are straight and level.

Figure 3

Vertical

Stabilizer

(21)

Tail

Screw (22)

REV 08j

SKU 92906 For technical questions, please call 1-800-444-3353. Page 5