Propeller Assembly
Slide the Spinner Nut (7), Propeller (9), and Shaft Adapter (24) assembly onto the Motor’s (6) shaft at the nose of the plane. Tighten the internal hex screw on the side of the Adapter (24). Make sure that the Adapter (24) does not rub or interfere with any other part during opera- tion.
Landing Gear Assembly
1.Push Landing Gear (10) into the slot located under the front of the Fuselage (3).
2.Insert Landing Gear Brace (26) into the slot and press it firmly into place.
IMPORTANT:
If damage is caused due to a crash, your warranty is void.
Battery Charging
1.Plug the Battery Pack (14) into the Charger (15) as shown in Figure 4, right. Plug the Charger
(15)into a 120V electrical outlet. Allow up to three hours for the initial charge. Do not leave unattended when charging. Disconnect the Battery Pack (14) from the Charger (15) when the charge is complete. The batteries will become warm when they are ready for use. If you feel them becoming overly hot, immediately disconnect the Charger (15).
Figure 4
Charger (15)
Battery Pack (14)
to Charger (15)
connection
Battery
Pack (14)
2.Make certain that the “On/Off” Switch for the
Airplane is in the “OFF” position. Turn the tabs at the edge of the Battery Cover (19) to the side and remove the Cover. Plug the Battery Pack (14) into the socket located underneath the Battery Cover (19). Insert the Battery Pack (14) into the Fuselage (3) and close the Battery Cover (19). Turn the tabs over the edge of the Cover to secure it.
3.Switch “OFF” the “ON/ OFF” Switch on the Remote Control (11). Remove cover and insert eight “AA” batteries (not included) into the Remote Control (11).
REV 06e
SKU 92906 | For technical questions, please call | Page 6 |
