SKU 92917 & 93253 For technical questions, please call 1-800-444-3353. Page 4
Guard against electric shock. Prevent body contact with grounded surfaces such
as pipes, radiators, ranges, and refrigerator enclosures.
Replacement parts and accessories. This product is to be repaired and serviced
only by a qualified technician. When this product is serviced, only identical replace-
ment parts should be used. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are available
from Harbor Freight Tools.
Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
Use proper size and type extension cord. If an extension cord is required for the
air compressor, it must be of the proper size and type to supply the correct current
to the compressor without heating up. Otherwise, the extension cord could melt
and catch fire, or cause electrical damage to the tool. Check your air compressor’s
manual for the appropriate size cord. It is also possible that the use of an exten-
sion cord may cause your circuit breaker to trip or your panel fuse to break. If this
happens, either use the compressor without an extension cord or find a larger
amperage circuit to use.
Maintenance. The maintenance outlined in the maintenance section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualified technician.
Compressed air only. Never use combustible gas as a power source.
Do not load nails with the trigger or safety depressed. Uninten-
tional firing may occur. Do not load nails when the air hose is con-
nected to the tool. Always assume the tool contains fasteners.
Disconnect air supply before loading the Nailer. Before reloading (or making
any adjustments to) the Nailer, make sure the compressed air is disconnected.
Fire fasteners into an appropriate work surface only. Do not attempt to fire
fasteners into surfaces too hard to penetrate. Do not drive fasteners on top of other
fasteners, or at too steep an angle. Fasteners can ricochet causing personal injury.
Never fire the Nailer into the air, or point it toward yourself or another person. Always
wear ANSI approved safety goggles during use, maintenance, and reloading.
Do not fire fasteners too close to the edge of a workpiece. They may split the
workpiece and fly free, causing personal injury.
Take caution, as some woods contain preservatives such as copper chromium
arsenate (CCA) which can be toxic. When stapling or nailing these materials extra
care should be taken to avoid inhalation and minimize skin contact.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.