Working with the Rechargeable Battery
Charging the Battery:
1.Batteries are normally shipped with low or no charge to prevent potential problems during shipment. Before use, you must charge your new Battery. Initial charge time is approximately 1 hour. Subsequent recharge time is approximately 1 hour.
2.Plug the battery charger into a 120 VAC, 60 Hz power outlet.
3.Insert the Battery into the charger by aligning the rib on the Battery with the groove in the charger. Press the Battery into place. The Red LED will illuminate indicating that a Battery is charging.
4.NOTE: During recharging, the Battery will become slightly warm to the touch. This is normal and not a cause for concern. Do not keep the Battery or charger in an environment of extreme heat or cold. They will work best at room temperature.
5.The Red LED will remain on for approximately 1 hour while the Battery charges. When the Battery is fully charged the charger will stop charging, the Red LED will go out, and the Green LED will illuminate indicating that the Battery is fully charged.
6.When the Battery is fully charged, remove the charged battery from the charger, and unplug the charger
from its power source. Put the charger away for safekeeping. Do not leave the Battery in the charger indefinitely.
Installing the Battery
1.Slide the Battery into the base of the handle. CAUTION: Do not press the battery into the handle if it is not properly aligned, as this may damage the body of the tool, and will not secure the battery.
Installing the Battery Pack
2.Be sure the Battery is properly installed before using the tool.
SKU 93722 | For technical questions please call | Page 6 |
