8.Depress the Nose (40) against the workpiece and squeeze the Trigger (58). The tool must cycle (fire) only once. Release the Trigger and squeeze it again. The tool must not cycle (fire). With the Trigger held, carefully lift the Nailer and press it against the workpiece again. The tool must not cycle (fire). If it fails to perform in the manner explained in bold, have it repaired by a qualified service technician.
LOADING NAILS
WARNING: Always wear ANSI approved impact safety goggles when reloading or performing any other maintenance on this tool. Other people in the work area must also wear ANSI approved impact safety goggles.
WARNING: Make sure the Nailer is not attached to the air hose when loading the tool.
Note: This Nailer only uses 280 collated nails.
1.Pull the Feeder Shoe (71) all the way to the rear until it latches.
2.Orient a strip of Nails (86, 87) with points down and drop the Nails into the Magazine (73).
3.Slide the Nails (86, 87) forward in the Magazine (73). The Magazine will hold 90 Nails.
4.Pull the Feeder Shoe (71) backward, and then press the Lock (77) to allow the Feeder Shoe to slide forward against the Nails (86, 87).
TRIGGER
(58) INSERT NAIL HERE
MAGAZINE
(73)
FEEDER SHOE
(71)
NOSE
(40)
SKU 93760 | For technical questions, please call | PAGE 7 |
