OPERATING THE NAILER
1.Attach the Nailer to the air supply at the Quick Connector (85). Start your compressor and check the pressure, making sure it is set at 90 PSI.
Do not exceed the maximum 125 PSI.
2.Rotate the Exhaust Cover (4) so that the exhaust air blast will be directed away from the operator.
3.To fire, place the Nose (40) of the Nailer on the workpiece. The Nailer should not fire if the Nose is not depressed. Once depressed, gently and briefly squeeze the Trigger (58) once; one Nail will be fired.
4.Do not press the Nose (40) against the workpiece with extra force. Allow the tool to do the work. Always allow the tool to recoil off the work surface.
5.When finished using the Nailer, always disconnect the tool from its air supply. Empty the Magazine Assembly (73) completely of Nails. Attempt to fire the Nailer into a piece of scrap wood to ensure it is disconnected and is incapable of firing any Nails.
6.Make sure to store the Nailer in a clean, dry, safe location out of reach of children.
EXHAUST COVER
(4)
QUICK CONNECTOR
(85)
TRIGGER
(58)
| MAGAZINE | NOSE |
|
|
|
|
| ||
| (73) | (40) |
|
|
|
|
|
| |
| For technical questions, please call | Rev 11/06 | ||
SKU 93760 | PAGE 8 | |||
