8.Make sure to position the Pump on a flat, level, solid surface.

3.Use the right product for the job. There are certain applications for which this product was designed. Do not use small tools, attachments, or equipment to do the work of larger industrial tools, attachments, or equipment.

4.Maintain a safe environment. Keep the area well lit. Make sure there is ade- quate surrounding space. Always keep the area free of obstructions, grease, oil, trash, and other debris. Do not use an electrically powered product in areas near flammable chemicals, dusts, and vapors.

5.WARNING! Risk of electrical shock. Always disconnect the Pump from its power source before handling or making any adjustments to the tool.

Always wear non-skid rubber boots when water is on the floor and you must unplug the Pump. Never allow the internal Motor to get wet. Make sure the electrical power source is a separately fused, grounded, 3-wire type GFCI (Ground Fault Circuit Interrupter) outlet. Do not remove the ground prong on the Power Cord Plug. Do not use an extension cord.

6.Do not pump hazardous materials. Do not pump explosive or flammable ma- terials such as fuel, oil, kerosene, gasoline, etc. Do not pump in close proximity to flammable or explosive materials. Do not pump fats, oils, salt or waste water.

This Pump is designed to move clean or dirty water only. Do not pump water over 95 degrees Fahrenheit.

7.Make sure the discharge pipe (not included) is secured to a solid surface to ensure the stability of the Pump.

8.Make sure to position the Pump on a flat, level, solid surface.

9.WARNING! Always arrange a “drip loop” in the Power Cord connect- ing the Pump to a 120 volt, GFCI electrical outlet. A drip loop is that part of the Power Cord below the level of the outlet to prevent water from traveling along the Power Cord and coming in contact with the outlet. If the Power Plug or elec- trical outlet does get wet, do not unplug the Power Cord. Disconnect the fuse or circuit breaker that supplies power to the Pump. Then, unplug the Power Cord and examine for presence of water in the outlet. (See Figure A.)

Drip Loop

FIGURE A

OUTLET

PUMP

DEVICE

OUTLET

CORD

SKU 93819

For technical questions, please call 1-800-444-3353

PAGE 5

93820

 

 

Page 5
Image 5
Harbor Freight Tools 93819, 93820 manual Make sure to position the Pump on a flat, level, solid surface, Drip Loop, Figure A