Attach the AdjustableTemperature Control Unit. | Keyhole hanger |
1.Mount the Adjustable Temperature Control Unit to a secure location using the keyhole hanger. The Control Unit must be mounted inside the building for the temperature control to function.
2.Attach the ring connectors from the Solar Panels to the contacts on the Control Unit marked “Solar”. Attach the power cords to the proper polarity. There should be two ring connectors on each terminal.
Attach the Exhaust Fan.
Mount the Exhaust Fan in your building using hardware (not supplied) in the holes drilled in
the edge of the fan. Be sure the fan is mounted securely, is protected from water and other local materials which may damage it. A protective grid (not supplied) must be installed on both sides of the fan to prevent injury.
CAUTION: The Fan may begin operating without notice whenever there is sufficient electricity in the system from either the Solar Panels or the battery.
Attach an optional 12V battery.
1.It is recommended that a 12V 20 Ah battery (not included) be installed to store spare electricity generated during the day so the fan can continue to operate after daylight hours.
2.Battery Connector (jumper cables) are provided. Connect the RED cable to the positive (+) connector of the Control Unit and the positive (+) pole of the battery. Connect the BLACK cable to the negative
CAUTION: The battery must be rated for 12V and at least 20
CAUTION: If the fan is disconnected, also disconnect the battery. The battery may be damaged if left connected to a solar panel system without the fan operating.
Setting the Adjustable Temperature Control Unit.
1.Adjust the desired temperature by rotating the dial on the front to the desired temperature. When the ambient temperature goes above the desired temperature, the fan will go on, the fan will go off when the temperature falls below the setting. The temperature range is 59° to 140° F (15° to 60° C).
2.The Control Unit has a built in regulator that will prevent battery discharge if the battery level is less than 10.5 Volts or overcharge if the battery charge is over 14.5 Volts.
SKU 94519 For technical questions please call | Page |
