Harbor Freight Tools 94585 Motor Housing #17 #16 Drill Chuck #2, Unpacking, Assembly, Page

(Continued from page 4)

are: lead from lead-based paints, crystalline cilica from bricks and cement or other masonry products, arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals; work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

(California Health & Safety Code 25249.5, et seq.)

UNPACKING

Your Air Drill comes completely assembled. Included is a chuck key for use with this tool. Check to make sure everything is included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.

ASSEMBLY

Your Air Drill is completely assembled. Follow the steps below to install drill bits and prepare for the operation of your Air Drill.

Drill Bit Installation

Step 1: Select the drill bit needed for the drilling you wish to perform.

Step 2: Open up the Jaws of the Drill by turning the DRILL CHUCK (#2) as shown in Figure 1.

Motor Housing (#17) (#16)

Drill Chuck

(#2)

Figure 1 — Opening the Jaws

Step 3: When the Jaws are open wide enough to insert the drill bit, slide the bit into the DRILL CHUCK as far as possible.

SKU 94585 For technical questions please call 1-800-444-3353. Page 5