INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Make sure the Power Switch (27) of the Belt Sander is in its “OFF” position and the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures. (See Figure E.)
2.Before each use: Inspect the general condition of the Belt Sander. Check for loose screws, misalignment or binding of moving parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.Before each use: Inspect the Sanding Belt (66). Using dull Sanding Belts will cause excessive wear on the motor of the Belt Sander and will not produce satisfactory sanding results. Replace with a new Sanding Belt when needed.
(See Figure E.)
4.To clean the exterior parts of the Belt Sander: Use only a clean cloth and mild detergent. Then dry. Do not immerse any electrical part of the tool in any liq- uids.
5.CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.
TROUBLESHOOTING
Problem |
| Possible Solution |
Belt Sander will not turn on. | 1. | Make sure to firmly squeeze the Power Switch. |
| 2. | Make sure the Power Cord/Plug is connected to a |
|
| working, 120 volt, grounded, electrical outlet. |
| 3. | Discontinue using the Belt Sander, and have a quali- |
|
| fied service technician check out the tool. |
Belt Sanding not removing material adequately | 1. | Do not apply excessive downward pressure on the |
from the workpiece. |
| Belt Sander. |
| 2. | Increase the speed of the Belt Sander. |
| 3. | Make sure the Sanding Belt is not dull or clogged with |
|
| excessive debris. |
| 4. | Use a coarser grit Sanding Belt. |
Gashes and hollows occur in the workpiece | Avoid tilting or rocking the Belt Sander or sanding in one | |
when sanding. | spot too long. | |
Sanding Belt slips off rollers of tool while in use. | Adjust the tracking of the Sanding Belt. | |
Power Switch will not turn the Belt Sander off. | Unplug the Belt Sander from its electrical outlet. Discon- | |
| tinue using the Belt Sander, and have a qualified service | |
| technician check out the tool. | |
SKU 94748 | For technical questions, please call | PAGE 12 |
