Harbor Freight Tools 94799 manual Controls and Indicators, Setup for Operation

7.Peel the Adhesive Pad backing from one of the Magnetic Strips and mount it parallel to, and no more than 1/4 inch from, the Sensor. See photos at the bottom of page 4.

8.Repeat steps 5 to 7 for each Sensor and Magnetic Strip.

9.Using a small round-head screw (not supplied), screw into the desired mounting location. Place the hole in the back of the Main Unit over the screw, and slide the unit down to lock in place.

Note: Not all the Sensors need to be used for the Wireless Home Alarm to work.

Operation

Controls and Indicators

Main Unit

Sensor LED lights when Sensor tripped.

RF+Alarm - Sensor On; Sensor Sounds when tripped. Sensor # lights on Main Unit.

Alarm - Loud noise

when Sensor tripped.

Off - Unit turned off.

Chime - Ding-dong sound when Sensor tripped.

Sensor

Off - Sensor turned off.

RF - Sensor On; No sound when tripped. Sensor # lights on Main Unit.

Setup for Operation

1.On each Sensor, push the slide switch to the desired operating position: RF+Alarm (signal and sound) or RF (signal, no sound).

2.On the Main Unit, push the slide switch to the desired operating position: Alarm (loud noise) or Chime (Ding-dong sound).

SKU 94799 For technical questions, please call 1-800-444-3353 Page 5