ASSEMBLY INSTRUCTIONS
1.
CAUTION! Make sure the Power Switch (42) of the Chipper/Shredder is in its “OFF” position and the unit is unplugged from its electrical outlet prior to performing assembly procedures.
To Attach The Wheels:
1.Move the Chipper/Shredder to a clean, dry, level area in which to perform the necessary assembly.
2.Place one Washer (24) on each end of the Axle (25). (See Figure E.)
3.Insert the ends of the Axle (25) through the two Vertical Frames (15).
(See Figure E.)
4.Place one Wheel (14) on each end of the Axle (25). (See Figure E.)
5.Place one Axle Ring (13) on each end of the Axle (25). (See Figure E.)
6.Secure the Wheels (14) to the Axle (25) by lightly tapping (with a hammer) an Axle Cap (12) onto each end of the Axle. (See Figure E.)
FIGURE E
AXLE RING | WASHER | WASHER | AXLE RING | ||||||
(13) | (24) |
| (24) | (13) |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| AXLE |
|
|
|
| ||
AXLE CAP |
| AXLE CAP | |||||||
(25) |
|
| |||||||
|
| ||||||||
(12) |
|
|
| (12) | |||||
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
WHEEL
(14)
VERTICAL FRAME
(15)
To Attach The Chute Cover And Hopper:
1.Slide the Chute Cover (7) downward over the upper portion of the Shredder
