6.From the Tire Inflation Unit, turn the Converse Valve counterclockwise, and open (inline with hose) the N2 Inlet valve.
•This step inflates the tire with Nitrogen.
•Check the Tire Pressure Gauge on the Tire Inflation Unit, and inflate to the tire manufacturer’s recommended tire pressure.
•The A or B N2 Generation Indicator will light. The N2 Pressure Gauge should read 85 PSI.
•Check the N2 Purity Analysis Display on the Main Unit. Purity should read between 95% to 99%. If it does not, N2 supply tank may be low.
7.When the tire is inflated to the proper pressure, close (90° to hose) the N2 Inlet valve, and remove the rubber hose with tire valve clamp from the tire valve.
8.Turn the Nitrogen Generator and Inflater Power Switch to the Off position.
9.Turn the air compressor off and disconnect the air hose from the Nitrogen Generator and Inflater.
TROUBLESHOOTING
| Problem |
| Probable Cause |
| Possible Solution |
|
|
|
|
| |
Tire does not inflate or | 1. | Air or N2 hoses not correctly | 1. | Review Assembly steps on | |
deflate. |
| connected. |
| page 8. | |
- | Power Switch on | 2. | Air Compressor not supplying | 2. | Check air compressor is on |
- | Power Indicator on |
| air pressure, or not |
| and hoses are correctly |
| connected. |
| connected. | ||
|
|
|
| ||
|
| 3. | Not following proper | 3. | Review operating procedure |
|
|
| operation procedure. |
| on page 9. |
|
| 4. | Tire valve hose connector not | 4. | Reconnect tire valve hose |
|
|
| inserted properly. |
| connector. |
|
|
|
|
| |
N2 Purity Analysis Display | 1. | Adjustment of the N2 Purity | 1. | Adjust the N2 Purity Flow | |
reads less than 95% |
| Flow Rate screw is required |
| Rate screw. | |
|
|
|
| ||
|
|
|
|
|
|
SKU 95105 | For technical questions, please call | Page 10 |
