Harbor Freight Tools 95386 operating instructions Unpacking, Operating Instructions

23.WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. The operator must understand that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

24. WARNING! The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249.5, et seq.)

TO:

AIR OUTLET

VALVE (63)

TO

AIRTOOL

OILER WATER

FIGURE C

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts Lists on page 15 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

OPERATING INSTRUCTIONS

NOTE: For additional information regarding the parts mentioned in the following pages, refer to the Assembly Diagrams on page 16.

1.IMPORTANT! Always fill the Air Compressor with a premium quality,

30-weight,non-detergent, compressor oil before each use. Running the Air Compressor with no oil or low oil will cause damage to the equipment and void the warranty. To check the level of oil, make sure the Air Compressor is OFF. Then, observe the Oil Sight Gauge (33). The level of oil should be within the red circle on the Oil Sight Gauge (33). (See Figure D, next page) If the level of oil is below the red circle, carefully unscrew and remove the Oil Plug (31) and

SKU 95386 For technical questions, please call 1-800-444-3353. Page 10