Page 5For technical questions, please call 1-800-444-3353.SKU 9576,
94639
reV 08e, 10a
sPecIFIcaTIOns
Model 9576 94639
Motor 12 VDC / 50 W
/ 4,500 RPM
12 VDC / 110 W
/ 4,500 RPM
Application
Utility Water
Pumping,
including
marine
applications
Utility Water
Pumping
Power Wires 18 AwG x 19” Long (Qty. 2)
Discharge
Height* 23 ft.
Flow Rate* 200 GPh 300 GPh
Self Priming Yes
Construction Stainless Steel Pump Housing
Steel Motor Housing
Dual Threaded
Inlet 3/8”-18 NPT Female I.D.
3/4” Male O.D.
Dimensions 5-3/4” L x 2-1/2” Dia. x 4” h
*note: For optimal performance, the
suction hose (not included) I.D.
must be at least the same size as the
suction ange and free of air leaks.
All joints and connections of the suction
hose should be securely tightened to
prevent air from entering the suction
side. Use a good grade suction hose
that will not collapse.
In addition, the height from the inlet
to the pump and then the height from
the outlet to the discharge will greatly
impact pump performance.
UnPacKIng
When unpacking, make sure the item
is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight
Tools at 1-800-444-3353 as soon as possible.
OPeraTIng InsTrUcTIOns
nOTe: For additional reference to the parts
mentioned in the following pages, refer
to the assembly Diagram at the end of
this manual.
nOTe: Mount the pump permanently to
a at surface only. Do not mount the
Pump on a rounded surface. (Hardware
for permanently mounting the Utility
Pump is not included.)
cOnnecT
sUcTIOn hOse
(nOT IncLUDeD)
here.
cOnnecT
DIscharge hOse
(nOT IncLUDeD)
here.
FIgUre a
1. The Inlet and Outlet Ports on the Utility
Pump are both dual threaded with an
Inside Diameter of 3/8” NPT and an
Outside Diameter of 3/4”. This allows
for more versatility in selecting a suction
hose and discharge hose (not included)
with the proper threaded male or female
connector. (see Figure a.)
If you are connecting a suction hose 2. having a threaded male connector,
wrap about 4” of pipe seal tape (not
included) around the threads of the
male connector. Then, rmly screw the
male connector into the threaded female
connector of the Utility Pump. Repeat