Page 6 For technical questions, please call 1-800-444-3353. SKU 9576,
94639
this process for the discharge hose
having a threaded male connector.
If you are connecting a suction hose 3. having a threaded female connector,
wrap about 4” of pipe seal tape (not
included) around the threads of the male
connector of the Utility Pump. Then,
rmly screw the female connector of the
suction hose onto the threaded male
connector of the Utility Pump. Repeat
this process for the discharge hose
having a threaded female connector.
note: Depending on the make/model of
boat on which the Utility Pump will be
used, there are many variations as to
connecting the Utility Pump to the boat’s
12 Volt DC electrical system. Therefore,
it is recommended that only a qualied
technician perform this procedure.
note: It is highly recommended that a circuit
protection device and control switch be
used when permanently installing this
pump. Refer to the section, “Specic
Product Warnings and Precautions” in
this manual for further instructions.
InsPecTIOn, MaInTenance, anD cLeanIng
TO PreVenT InJUrY
anD FIre FrOM
accIDenTaL OPeraTIOn Or
sParKIng:
Turn the Boat’s Ignition switch to
its “OFF” position and
disconnect the Power cords (1)
from the boat’s 12 Volt Dc
electrical system before
performing any inspection,
maintenance, or cleaning.
BeFOre each Use,1. inspect the
general condition of the Utility Pump.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged electrical wiring,
loose or leaking suction and discharge
hoses, and any other condition that may
affect the safe and efcient operation
of the Utility Pump. If abnormal noise
or vibration occurs, have the problem
corrected before further use. Do not
use damaged equipment.
When necessarY:2. With a clean, dry
cloth, or vacuum, remove all dirt and
debris from the Utility Pump.
PLease reaD The FOLLOWIng careFULLY
ThE MANUFACTURER AND/OR DISTRIbUTOR
hAS PROVIDED ThE PARTS LIST AND ASSEMbLY
DIAGRAM IN ThIS MANUAL AS A REFERENCE
TOOL ONLY. NEIThER ThE MANUFACTURER OR
DISTRIbUTOR MAKES ANY REPRESENTATION OR
wARRANTY OF ANY KIND TO ThE bUYER ThAT hE
OR ShE IS QUALIFIED TO MAKE ANY REPAIRS TO
ThE PRODUCT, OR ThAT hE OR ShE IS QUALIFIED
TO REPLACE ANY PARTS OF ThE PRODUCT. IN
FACT, ThE MANUFACTURER AND/OR DISTRIbUTOR
EXPRESSLY STATES ThAT ALL REPAIRS AND
PARTS REPLACEMENTS ShOULD bE UNDERTAKEN
bY CERTIFIED AND LICENSED TEChNICIANS,
AND NOT bY ThE bUYER. ThE bUYER ASSUMES
ALL RISK AND LIAbILITY ARISING OUT OF hIS OR
hER REPAIRS TO ThE ORIGINAL PRODUCT OR
REPLACEMENT PARTS ThERETO, OR ARISING OUT
OF hIS OR hER INSTALLATION OF REPLACEMENT
PARTS ThERETO.