Figure 4A
Hex Wrench for Set Screw (included)
1.Insert the Needles (5A) through the holes in the Needle Holder (4A). There are nineteen Needles. Make sure all holes are filled before putting the Needle Holder (4A) through the Spring (3A), the Retainer Clip (2A) and into the Barrel Assembly
(1A). Slide one Retainer Ring (8A) around the Needles (5A) and fasten it at the front end of the Barrel Assembly (1A). See Figures 4 & 4A
Figure 5
Hole for Set Screw
8A | 7A | 6A | 1A | 2A | 5A |
2.Holding the Barrel Assembly (1A) in one hand with the Needles (5A) pointing down- ward, insert the Needle Driver (6A), the Screw Cap (7A) and the last Retainer Ring (8A). See Figures 4 & 5
3.The Screw Cap (7A) has a Set Screw that holds it in place. Be very careful NOT to tighten the Set Screw too tightly, snug is good. Otherwise you may damage the plastic threads inside the Screw Cap (7A) causing it to bind or strip some threads.
4.Insert the Barrel Assembly (1A) into the end of the Air Hammer Housing (1) and thread the two parts together. As before do not over tighten, snug is good.
5.The Air Hammer is now ready to be used as a Scaler.
SKU 95801 | For technical questions, please call | Page |
