Filling the Fuel:
1.Prior to the initial use of the Chipper/Shredder, the fuel tank MUST be filled with approximately one half gallon of unleaded gasoline with a pump octane rating of 86 or higher.
2.Remove the Fuel Tank Cap and fill the fuel tank with unleaded gasoline. Then, replace the Fuel Tank Cap. When necessary, refill the Fuel Tank.
Draining The Fuel Tank and Carburetor:
1.Place an approved gasoline container below the carburetor. Be prepared to hold a funnel beneath the Drain Bolt to direct the gasoline into the container.
2.Remove Drain Bolt and Sediment Cup and move the Fuel Valve lever to the “ON” position.
3.After the Fuel has drained, reinstall the Drain Bolt and Sediment Cup.
NOTE: Periodically check the Sediment Cup for excessive dirt and debris, when neces- sary clean with nonflammable solvent.
Air Filter
1.Remove the Wing Nut and Air Cleaner Cover.
2.Carefully remove the plastic grid and foam air filter from the bottom of the cover.
3.Wash the air filter in warm water with a mild,
4.Wipe the inside of the air cleaner base and cover using a moist towel.
5.Return the clean (or new) air filter to the Air Cleaner Cover and put plastic grid back in place.
SKU 95964 | For technical questions, please call | Page 9 |
