Harbor Freight Tools 96144 manual Mounting, For technical questions, please call

2.Using a small flat head screwdriver or similar tool, pull out the Fuse (12) from the Fuse Holder (18)-see Figure 1.

3.Do not replace with a different size fuse, as this may result in excessive heat build up and explosion, which can damage the CarHeater/Fan and cause injury.

Mounting

1.The Heater/Fan can be permanently mounted to the vehicle using Mounting Screws

(21)or can be mounted using the Adhesive Tape as desired. Mount the Heater Fan so that it is out of direct sunlight. Do not mount the Heater Fan on upholstered seats or flammable surfaces.

2.When using Mounting Screws, make certain that all drilling paths are clear of elec- trical lines, cables, wire and any other obstructions.

3.Make certain that there is sufficient length in the Power Cord to reach the Cigarette lighter.

4.Use the Mounting Base (6) as a guide to mark two holes in the desired surface. Drill holes in the desired surface.

5.Align the holes in the Mounting Base (6) with the drilled holes. Mount the Mounting Base (6) using Mounting Screws (21).

6.When using the Adhesive Tape (21) mount as follows:

Make certain that there is sufficient length in the Power Cord to reach the Cigarette lighter. Wipe the Base (6) with alcohol for a grease-free surface. Peel off one face of the Adhesive Tape (21). Place the tape on the face of the Base (6) and press down and hold for one minute to adhere.

7.Prepare the mounting surface on the car following the same procedure as indicated in the above mentioned paragraph. Peel the tape backing carefully and position the Base (6) on the surface and press into place. Leave in place for an hour before use.

SKU 96144 For technical questions, please call 1-800-444-3353. Page 5