Harbor Freight Tools 97385 operating instructions Operating Instructions, Tool Set Up

2.Insert the Vacuum attachment (12) onto the center Screws. Attach one Washer (15) onto each Screw. Attach the Slide Knobs (10) to the Screws and tighten. (See Assy. Diagram.)

3.Insert the Extension Rods (2) into the outer channels of the Fence Slide (5) at the Fence (1) side.

(See Assy. Diagram.)

4.Slide the head of the Carriage Screws (14) into the center channel of the End Slide (6).

(See Assy. Diagram.)

5.Attach the Block Stop (7) to the protruding Carriage Screw (14) while aligning the tangs on the Block Stop with the center channel face of the Fence Slide (5). Attach a Flat Wash- er (15) and Knob (11) to the Screw and tighten.

NOTE: The Block Stop slides through the entire length of the Fence Slide. Use the Block Stop for repeti- tive work. If not needed, loosen the securing Knob (11) and slide the as- sembly off the Fence Guide (2).

(See Assy. Diagram.)

6.Attach the “C” Clamp (9) onto the Carriage Screws (14), noting that one end is locked into the slot in the Fence (1) and the other end rests on the Extension Rod (8). Attach a Washer (15) and Knob (11) and tighten. (See Assy. Diagram.)

7.Position a Guide (2) under the Fence

(1).Insert T-Screw (4) from under- neath through Guide (2), Fence (1) and Washer (15). Screw Lock Knob

(3)onto T-Screw (4) and tighten clockwise. Attach the other Guide using the same procedure. To at- tach and secure the Router Table

Fence on a Router Bed, slide the two Guides (2) onto the rails on the Rout- er Bed. (See Assy. Diagram.)

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

WARNING To prevent serious injury

from accidental operation: Make sure the power switch of the router or drill press is in its “OFF” position and the machine is unplugged from its electrical outlet before performing any set up procedures.

1.After the Router Table Fence is mounted to the router/drill press table top, adjust the Router Table Fence by loosening the two Adjusting Screws

(3). (See Assy. Diagram.)

2.Slide the Router Table Fence forward or backward to where you need to stop your material. Then tighten the two Adjusting Screws (3) to secure the Router Table Fence in place. Always tighten both Adjusting Screws to ensure a secure connection.

(See Assy. Diagram.)

3.An additional adjustment may be made to where you need to stop your material. Loosen the Knob (11) on

SKU 97385 For technical questions, please call 1-800-444-3353. Page 5