Assembly Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Note: The Greenhouse is heavy and unwieldy when fully assembled. It should be assembled near the area where it will be anchored. The area should be firm, level, and provide shelter from the wind.
Figure for Slat Assembly (Steps 1-3)
1.Slide two Rafter Slats (O) into the sleeves on the top of the Front Panel
(K).
2.Slide two Side Slats (P) into the sleeves on the sides of the Front Panel.
3.Slide Bottom Slat (Q) into the sleeve on the bottom of the Front Panel.
Figure for Pole Assembly (Steps 4-6)
4.Fit the covered Rafter Slats into the grooves in the Rafter Poles (G) and slide into place, with the holes on the Rafter Poles facing toward you (see insets above).
5.Fit the covered Side Slats into the grooves in the Side Poles (H) and slide into place, with the holes on the Side Poles facing toward you.
6.Fit the covered Bottom Slat into the groove in the Bottom Pole (F) and slide into place, with the holes on the Bottom Pole facing toward you.
Figure for Connector Ass’y (Steps 7-8)
7.Secure the Rafter Poles together at the peak of the roof using Connector A. Make sure the unconnected point on the Connector faces towards you.
SKU 97439 | For technical questions, please call | Page 4 |
