Power Cord Plug. Never remove the grounding prong or modify the Power Cord Plug in any way. Do not use adapter plugs with this product.
3.To assemble the two Wheels (9), insert the Axle (8) through the two holes located at the bottom/rear of the Base Frame (3). Place the Wheels onto the protruding ends of the Axle. Then secrure the Wheels in place, using one Bolt (10) for each end of the Axle. (See Assy. Diagram.)
4.To attach the Handle (30), align the two holes in the Handle with the two threaded mounting holes located at the top of the Case (28). Secure the Handle to the Case, using two Screws (31). (See Assy. Diagram.)
allow access by children or pets to prevent injury and distraction.
2.Route the Power Cord (32) along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working. The work- pieces should be firmly held together and in position while welding. The distance (if any) between the two workpieces must be controlled properly to allow the weld to hold both sides securely while allowing the weld to penetrate fully into the joint.
OPERATING INSTRUCTIONS
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious
injury from accidental operation:
Turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures.
Workpiece and Work Area Set Up
1.Designate a work area that is clean and
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
5.A barrier, such as a welding curtain or welding shroud, should be put up to protect others in the work area and limit the spray of sparks.
SKU 97719 | For technical questions, please call | Page 10 |
