Specifications
| 240 V~ / 60 Hz / Single Phase | |
Electrical | Power Plug Type: | |
Requirements | 240 Volt, | |
| (Not Included) | |
Output Current | AC 55 - 135A | |
DC 30 - 105A | ||
| ||
Max. Input | 40 Amps Operating | |
Current | ||
| ||
Indicators | Power On Light (Green) | |
Thermal Overload Light (Orange) | ||
| ||
Welding | Up to 1/4” (using 1/16”, 3/32” or 1/8” | |
Capacity | ||
diameter electrodes) | ||
Thickness | ||
| ||
Duty Cycle | 10% @ 130 Amps AC | |
15% @ 100 Amps DC | ||
| ||
Load Voltage | 25.2V (AC operation) | |
24.2V (DC operation) | ||
| ||
Open Circuit | 68V (AC operation) | |
Voltage | 60V (DC operation) | |
| Welding Shield (Qty. 1) | |
Accessories | Hammer/Brush (Qty. 1) | |
Electrode Holder (Qty. 1) | ||
| ||
| Ground Clamp (Qty. 1) |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious
injury from accidental operation:
Turn the Power Switch of the Arc Welder to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.To assemble the Welding Shield, place the Shield on a flat surface.
Press the Handle into place. Then insert the Filter Lens.
(See Figure A.)
FIGURE A
2.This Welder requires the attachment and use of a
REV 09d; 09l
SKU 97719 | For technical questions, please call | Page 9 |
