7.Never allow people or animals to stand or climb on this product.
8.Pinch point warning: Use caution to avoid pinching fingers when assembling and setting up this unit.
9.Adults only should perform the assembly and
10.When in use, make sure all Legs of the product are flat on the ground.
11.The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Save these instructions.
Specifications
Construction | Unfinished Fir | |
Yellow/Green Zinc Plated Steel Bolts, | ||
Material | ||
Washers, Nuts, and Screws | ||
| ||
Weight Capacity | 400 Pounds Total | |
(Distributed Evenly) | ||
| ||
Umbrella Hole | ||
Diameter | ||
| ||
Waterproof | No | |
Water Resistant | ||
|
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Assembly
Note: For additional information regarding the parts listed in the following pages, refer to the accompanying illustrations.
1.Attach the two Folding Beams (2) flush to the inner side of the Table Top (5), using six Bolts each with two Washers and one Nut (9). (See Figure A.)
2.NOTE: The Bolts and Washers (9) should be inserted from the outside of the Table Top (5) into the Folding Beams
(2). (See Figure A.)
FIGURE A
TABLE TOP (5)
FOLDING BEAM (2)
BOLTS, WASHERS, NUTS (9)
3.Place and align the Short Bench Top (8) flush on the two Bench Supports (4).
(See Figure B.)
4.Fasten the eight Screws (11) into the
Figure B.)
| SCREWS (11) | FIGURE B | |
SHORT |
|
|
|
|
|
| |
BENCH |
|
|
|
TOP |
| BENCH SUPPORT (4) | |
(8) |
|
SKU 97736 | For technical questions, please call | Page 3 |