Harbor Freight Tools 97736 manual See Figure C, See Figure D, See Figure G

5.Turn the assembled Bench upside down.

6.Position the Diagonal Supports (7) so one end is against the longer cross beam of Bench Support (4) legs. Then align the other end so it is flush to the wood edge next to the center gap of the Short Bench Top (8). The two Diagonal Supports (7) need to be attached at opposite sides of the bench gap, using three Screws (11) per Support. (i.e., one support will be attached to one bench slat, and the other bench slat will be attached to the other bench support.

(See Figure C.)

7.NOTE: There are no pre-drilled holes for the Screws (11) in the bench slat or Bench Supports (4). Instead, there are guide marks in the wood to indicate where the Screws must be inserted.

(See Figure C.)

BENCH

SUPPORTDIAGONAL

(4)SUPPORT

(7)

SHORT

BENCHFIGURE C

TOP (8)

8.Set the Table on its side.

9.Attach the Folding Beams (2) to the outside edge of the Bench Supports (4), using two Bolts, each with four Washers, and one Nut (10).

(See Figure D.)

FOLDING BEAM (2)

FIGURE D BOLTS, WASHERS, NUTS (10)

10.Hold the Table securely in its standing position.

11.Attach the two Table Legs (1) to the Table Top (5) by inserting two Bolts each, with four Washers and one Nut (10) into the pre-drilled hole at the rounded end of the Table Legs. NOTE: One pre-drilled hole still remains below the Table Legs. (See Figure E.)

TABLE TOP (5)

TABLE LEG

(1)BOLTS, WASHERS, NUTS (10)

FIGURE E

12.Attach the two Arm Rests (3) to the Table Legs (1), using two Bolts, each with four Washers and one Nut (10). (See Figure

F.)

FIGURE F

TABLE LEG (1)

	BOLTS
ARM	WASHERS
REST	NUTS
(3)	(10)

13.Place the Long Bench Top (6) on the Table Legs (1). Make sure the longer bar underneath the Long Bench top is toward the outside.

(See Figure G.)

14.Fasten the eight Screws (11) into the pre-drilled holes in the Long Bench Top

(6) to the Table Legs (1).

(See Figure G.)

SKU 97736 For technical questions, please call 1-800-444-3353. Page 4