Harbor Freight Tools 97855 operating instructions Save These Instructions Symbols Specific Safety

g.Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended for use with the specific tool model, increases the risk of injury to persons.

Service

a.Tool service must be performed only by qualified repair personnel.

b.When servicing a tool, use only identical replacement parts. Use only authorized parts.

c.Use only the lubricants supplied with the tool or specified by the manufacturer.

Air source

a.Never connect to an air source that is capable of exceeding 115 psi. Over pressurizing the tool may

cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated air-pressure range.

b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.

SAVE THESE

INSTRUCTIONS.

SYMBOLS AND

SPECIFIC SAFETY

INSTRUCTIONS

Symbol Definitions

Symbol	Property or statement
no	No-load speed
.../min	minuteRevolutions or reciprocation per
PSI	Pounds per square inch of pressure
ft-lb	Foot-pounds of torque
BPM	Blows per minute
CFM	Cubic Feet per Minute flow
SCFM	Cubic Feet per Minute flow at
	standard conditions
NPT	National pipe thread, tapered
NPS	National pipe thread, straight
	WARNING marking concerning Risk
	of Eye Injury. Wear ANSI-approved
	eye protection.
	WARNING marking concerning Risk
	of Hearing Loss. Wear hearing
	protection.
	WARNING marking concerning Risk
	of Respiratory Injury. Wear NIOSH-
	approved dust mask/respirator.
	WARNING marking concerning Risk
	of Explosion.

SKU 97855 For technical questions, please call 1-800-444-3353. Page 5