Harbor Freight Tools 98059 manual Scale Set Up, Charging the Battery, Operating Instructions

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn off and unplug the unit before performing any inspection, maintenance, or cleaning procedures.

Scale Set Up

1.Always place the Scale on a clean, dry, flat, level workbench capable of supporting the weight

of the Scale and all objects to be weighed.

2.The workbench area must be free of vibration, strong air currents, direct sunshine, and high temperatures.

3.To level the scale before use:

d.Turn the scale upside down.

e.Rotate the Leveling Feet (15) clockwise until they are fully recessed. Then turn counterclockwise three full turns. Hold each foot and rotate the locking nut two full clockwise turns or until

the locking nut is not tightened on the foot.

f.Turn the scale right side up and place on the work surface. Use the built-in leveling bubble at the front left hand side of the Scale to check if the scale is level. Rotate the feet individually until the leveling bubble is centered.

g.When the scale is level, secure each foot in place by turning its locking nut counterclockwise until tight. Re-check the level, and re-adjust the feet if necessary. The scale is now set for operation.

8.Check that the Scale’s Platform (1) will not come in contact with any object before or during the weighing process.

9.Route the AC/DC Adapter (25) Cord along a safe route to reach the workbench area without creating a tripping hazard or exposing the Cord to possible damage.

Charging the Battery

FIGURE A

(BOTTOM VIEW)

AC/DC ADAPTER CORD	POWER SWITCH
(25)	(11)

CHARGING INPUT PORT

LEVELING FOOT (15)

1.To charge the Battery (21) of the Scale, insert the AC/DC Adapter (25) Cord into the Charging Input Port located on the underside of the Scale. Make sure the Power Switch (11) is

in its “OFF” position throughout the charging process. Plug the AC/DC Adapter into the nearest 120 volt, grounded, electrical outlet.

IMPORTANT: The charge time for the Battery is 8 to 10 hours. Do not overcharge the Battery to avoid damage to the Battery and/or AC/DC Adapter.

When finished charging, unplug the AC/DC Adapter from its electrical outlet. Then unplug the Cord from the Charging Input Port of the unit.

SKU 98059 For technical questions, please call 1-800-444-3353. Page 6