y Safet
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off‑position and unplug the tool from its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
p Setu
1.BEFORE EACH USE, inspect the general condition of the tool. Check for:
•loose hardware,
•misalignment or binding of moving parts,
•damaged cord/electrical wiring,
•cracked or broken parts, and
•any other condition that may affect its safe operation.
Troubleshooting
2.AFTER USE, wipe external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
Operation
ec
Maintenan
Problem |
| Possible Causes |
| Likely Solutions |
Tool will not start. | 1. | Cord not connected. | 1. | Check that cord is plugged in. |
| 2. | No power at outlet. | 2. | Check power at outlet. If outlet is unpowered, |
|
|
|
| turn off tool and check circuit breaker. |
|
|
|
| If breaker is tripped, make sure circuit is right |
|
|
|
| capacity for tool and circuit has no other loads. |
| 3. | Internal damage or wear. | 3. | Have technician service tool. |
|
| (Carbon brushes or |
|
|
|
| Trigger, for example.) |
|
|
Excessive noise | Internal damage or wear. (Carbon | Have technician service tool. | ||
or rattling. | brushes or bearings, for example.) |
|
| |
Sander not sanding | 1. | Possible sandpaper problem. | 1. | Check sandpaper for wear and or damage. |
effectively | 2. | Possibly wrong grit of paper. | 2. | Fine sandpaper is graded in large numbers |
|
|
|
| (100 to 600). Coarse paper smaller numbers |
|
|
|
| (36 to 80). Not all are available. |
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts.
Page 10 | For technical questions, please call | Item 98622 |
