to perform in the manner explained in bold, have it repaired by a quali- fied service technician.
WARNING! Disconnect the Nailer from the air compressor when- ever loading or servicing.
ALWAYS WEAR ANSI- APPROVED IMPACT SAFETY GOGGLES WHEN RELOADING OR DOING ANY
OTHER MAINTENANCE ON NAILER. Other people in work area must also wear ANSI- approved safety goggles.
Loading Nails
1.CAUTION! Make sure Nailer is not attached to the air hose when loading tool.
2.CAUTION! Keep Nailer pointed away from yourself and others at all times. Always disconnect Nailer from its air supply before loading nails. Do not load Nails with Trigger (56) or Safety (37) depressed.
3.Pull the Feeder Shoe (69) all the way to the rear, until it latches.
4.Orient a strip of nails with the tips down and drop the strip of nails into Magazine (71).
5.Slide the strip of 60
6.Unlatch the Feeder Shoe (69) and allow Feeder Shoe to slide forward against strip of nails.
Operating Framing Nailer
1.Adjust the Exhaust Cover (4) to direct as desired.
2.To fire a nail, place the nose of the
Nailer on the workpiece. The Nailer should not fire if the Safety (37) is not depressed. Once the Safety is depressed, gently and briefly squeeze the Trigger once to fire one nail. Release the Trigger.
Do not fire repeatedly; nails could bounce off on one another, damaging the workpiece or causing personal injury.
3.Move the Nailer to another spot on the workpiece and squeeze the
Trigger again to fire another nail. Continue firing nails as needed.
4.When the work is completed, discon- nect the air supply and remove the nails from the nailer.
Operating Framing
Nailer
1.The depth to which a nail is driven is controlled by the Safety (37).
2.To adjust the depth of drive, loosen the Screw (39). Slide Safety up or down to the desired position. Then,
3.Test fire a nail, and check its depth of drive. Repeat Step #2 as necessary to achieve the desired depth of drive.
SKU 98733 | For technical questions, please call | Page 10 |
