Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions |
Air leaking in | 1. | Loose Screw (6). | 1. | Tighten and recheck. |
Cylinder Cap (8A). | 2. | 2. | Replace | |
Lack of power. | 1. | Tool is too dry. | 1. | Add about 3 drops of pneumatic tool oil into |
Slow to cycle. |
|
|
| the Air Plug (83). |
Low power when | 2. | Air pressure too low. | 2. | Check to make sure regulator on air |
shooting and |
|
|
| compressor is set between 70 PSI and 120 |
returning. |
|
|
| PSI. (70 PSI is the minimum where the Nailer |
|
|
|
| may work. If power is too low, set it between |
|
|
|
| |
| 3. | Exhaust blocked. | 3. | Clean exhaust channel. |
Not shooting | 1. | Damaged Torsion Spring (76). | 1. | Replace Spring. |
fasteners or | 2. | Wrong size of fasteners. | 2. | Use |
only intermittent |
|
|
| Nails. |
feeding. | 3. | Magazine (71) is dirty. | 3. | Clean Magazine. |
| ||||
Fastener is | 1. | Feeder Shoe (69) is broken or | 1. | Replace Feeder Shoe. |
jammed in tool. |
| worn. |
|
|
| 2. | Bent fasteners. | 2. | Remove bent fasteners. Replace with new |
|
|
|
| Nails. |
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified
to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
REV 09g,09i; 09l
SKU 98733 | For technical questions, please call | Page 13 |
