Air Coupler (95)
Trigger (59)
Magazine (79)
Figure 1
Safety Nosepiece (42)
3.The Nailer should not fire if Safety
Nosepiece (42) is not depressed against the workpiece.
4.Make sure Trigger (59) and Safety Nosepiece (42) move freely, with- out sticking. Do not use nailer if Trigger or Safety sticks.
5.Connect air supply to the Air Coupler
(95).Set the regulator at the recom- mended 70 to 120 PSI.
6.Test by depressing Safety Nosepiece
(42)against the workpiece without pulling the Trigger. The Tool must not cycle (fire). If it cycles (fires), stop immediately and have it repaired by a qualified service technician.
7.Hold tool away or off of workpiece. The Safety Nosepiece should return to its original position. Squeeze Trigger. The tool should not cycle
(fire). If the tool fires, stop immedi- ately and have it repaired by a quali- fied service technician.
8.Depress Safety Nosepiece against workpiece and squeeze Trigger. The tool must cycle (fire) only once.
Release the Trigger and squeeze it again. The tool must not cycle
(fire). With the Trigger held, carefully
lift the Nailer and press it against the workpiece again. The tool must not cycle (fire). If it fails to perform in the manner explained in bold, have it repaired by a qualified service techni- cian.
WARNING! Disconnect the Nailer from the air compressor whenever loading or servicing.
WEAR
Loading Nails
Tab (75)
Lock (88)
Figure 2
1.Slide the Tab (75) back and the Lock
(88)will hold it in place. See Figure 2, above.
2.Load a stick of nails (not included) into the top slot, making sure nail heads are facing up.
3.Be Careful. When Lock is released, the Tab will automatically and force- fully slide forward. Keep your fingers clear when releasing Lock.
4.Note: The Nailer may not work if there are only a few nails left in the tool. If there are only a few nails remaining, simply load another strip
SKU 98751 | For technical questions, please call | Page 11 |
