an air valve that will allow the air tool to retain pressure and operate accidentally after the air supply is disconnected.
Note: Air flow, and therefore tool perfor- mance, can be hindered by under- sized air supply components.
3.The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.
4.Close the
5.Turn on the air compressor according to the manufacturer’s directions and allow it to build up pressure until it cycles off.
6.Adjust the air compressor’s output regulator so that the air output is enough to properly power the tool, but the output will not exceed the tool’s maximum air pressure at any time. Adjust the pressure gradually, while checking the air output gauge to set the right pressure range.
7.Inspect the air connections for leaks. Repair any leaks found.
8.If the tool will not be used at this time, turn off and detach the air supply and safely discharge any residual air pressure.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a good safety measure to attempt to discharge the tool in a safe fashion after disconnecting to ensure that the tool is disconnected and unpowered.
Operation
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired.
Testing the Full Sequential
Safety Trip Mechanism
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION: Detach the air supply, safely discharge any residual air pressure in the tool before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY: Do not adjust or tamper with any control or component in a way not specifically explained within this manual. Improper adjustment can result in tool failure or other serious hazards.
1.WARNING! Even though the Nailer should be empty during this proce- dure, ALWAYS point the Nailer at a piece of scrap wood when testing.
2.Completely empty Magazine (79).
SKU 98751 | For technical questions, please call | Page 10 |
